Jump to content

Possible issue with 3D design page

Low Carbon Exchange

Recommended Posts

Hi Team,

I have just created 22 PV arrays in one design and when i click the 3D design button across the top you can then see the list of arrays down the left hand side and underneath each array is where you can enter in the degradation of the module. As there are 22 arrays i need to use the page slide to see the ones at the bottom however this does not show the last 4. I have used the keyboard down arrow to adjust the module degradation but thought you would like to know so this can be fixed in the next release.

I have PV Sol Premium 2019 (R5) and i have attached a screen shot.


PV Sol screen shot.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...