Search the Community
Showing results for tags 'reference'.
Hi all, I have a question about defining a reference edge on a imported 3D model. I've replied to a topic in wich you suggested how to do this but that option is not available when I work with an imported 3D model. This reply is shown below and can be found at https://forum.valentin-software.com/topic/465-correct-angle-of-3d-extruded-map-building/: _____ Hi there, I am wondering how you can define your reference edges? As you stated: I work a lot with 3D .dae models from sketchup. When I model a building in PVSOL, I have the option to define the reference edge. When I use the 3D model I don't see this option, and I am forced to wiggle about with the degrees of the orientation of the modules. Am I missing something here or can you please direct me into the right direction? Should I open a new topic for this, for possible future inquiries about this matter? Thank you in advance! _____ Since no reaction has been given yet, I'm opening this new topic. Please advise, it's not intuïtive nor efficiënt to haggel about with degrees. Thank you very much in advance and I hope to hear for you! Benjamin