Will Posted September 11, 2017 Report Posted September 11, 2017 Hi, When I perform the shading simulation for the plant; I identified the "Average value" that meets my design criteria which is 2% as an acceptable limit. How can the software automatically remove the panels that are experiencing above 2% shading frequency? Thanks in advance, Will Quote
hotline_tm Posted September 14, 2017 Report Posted September 14, 2017 Dear Will, this is unfortunately not possible. You cannot enter a limit from which all modules that exceed this limit will be removed automaically. Please note: The percentages on the modules represent the direct radiation reduction over the year and are not equal to the yield reduction due to shading. This depends on the time when the reduction takes place. Reductions during the sunrise and sunset or at the winter time have less impact than at midday in the summer. Regards Your Technical Support Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.